How-To Guide

Nowwe ’ 11 see the names and roles of all the blocks.
r
NRl l1[: :]r.Ii]~ :~빼 e 810ck
S 없 rt
Move
TumonLED
Tum offLED
MakeSound
Wait
If
Repeat
Else
Close block
Function
Number block
Direction 810ck
Sensor block
Dial block
8rain block
톨웰톨 l
톨햄를1:11
톨훨페 n
톨웰률 1
톨월 I 괴
톨빨톨:1
톨벌 l 괴
톨짧톨 i
톨圖를 l
률뭘웰 l
3
7
딛됨
SLeingshotr
Front Li ne
Sensor Sensor
I 숫숲뚫
It means that all commands are started.
The "START" block should always be on top.
It
’5 a command to move the robo t.
You can adjust the direction using direction blocks.
Turn on the robot
’5 lamp. You can a 이 ust the position
of the lamp using the direction block, and you can
a 이 ust the color using the number block.
Turn
off the lamp on the robo t.
까 le robot makes a 없 md. Wh en you ∞ nnect a number b lock,
you can make the robot make the 5ωnd of cars, robot, puppy,
cat, chicken, tiger or and lion, depending on the number.
The robot waits without performing any action.
You can
set the time to wait by connecting the number
block
or the dial block.
It can be connected
to the sensor block.
If “口口" is detected by the “口口" sensor ...
From here
, the command blocks up until the ‘CLOSE’
block are repeated.
Number
of repetitions when ∞ nnecting a number block.
Mark the ends
of the "IF" and "REPEAT" blocks.
It remembers the combined command blocks
at once.
2, 3, 4, 5, 6, 7
It controls the direction of the robot according to the
direction inserted.
It is used together with the "FRONT SENSOR"
,
"BOTTOM SENSOR", "LlGHT SENSOR" and "IF" blocks.
It acts like a number block. You can change the number
by turning the dia l. (Possible to choose from 0.1 to 99.)
It must always be
at the bottom.
It collects all the commands under the "START" block
and sends them to the robo
t.
15