User manual

13
CNet Global Technology Inc.
www.CNetusa.com
Step5: Complete the hardware installation as diagram at below
Notes: Use Reset button on POE injector. Push continually the reset button of POE injector about 5 ~10 seconds to reset
the configuration parameters to factory defaults.
There is no software driver or utility installation needed, but only the configuration setting. Please re-
fer to chapter 4 for software configuration.
Notice: It will take about 50 seconds to complete the boot up sequence after powered on the Outdoor Router; Power LED
will be active, and after that the WLAN Activity LED will be flashing to show the WLAN interface is enabled and working
now.