User manual

3-2 User Manual
2. Plug the male (9-pin) serial cable into the RS-232C connector at the
back of the modem. See chapter 2 for the location of the
connectors.
3. Plug the other end of the serial cable into your system’s serial port
(COM1 or COM2 on your system).
4. Plug the telephone cable into the LINE jack located at the back of
the modem. See chapter 2 for the location of the jack.
5. Plug the other end of the telephone cable into a telephone wall jack.
6. Plug the AC adapter power cord into the AC 9V connector located at
the back of the modem. See chapter 2 for the location of the
connector.
7. Plug the transformer end of the adapter into a standard AC wall
outlet.
8. To connect a telephone to the modem:
a. Plug the telephone to the modem PHONE jack.
b. Lift the handset and listen for a dial tone to check for a working
connection.
9. To connect a speaker and a mic to the modem:
a. Plug the speaker in to the modem SPK connector.
b. Plug the mic in to the modem MIC connector.
10. Turn your modem on. The modem should perform a self-test and
then be ready for use. After every thing checks out, turn your
computer on.
NOTE:
Make sure that your modem is turned off before you plug in the
AC adapter. Also check the voltage range in your area before plugging
your system into an outlet.