Specifications

Installing PCBs
DS2000 Hardware Manual Section 2: PCB Installation ◆ 2-13
2
DID Programming (Basic)
● 1401 - Number of DID Digits
Specify the number of DID Digits (1-8) expected from the telco.
● 1402 - DID Translation Table
Set up the system’s DID routing.
Refer to your Software Manual for additional options for setting up DID Camp On and DID Overflow.
Tie Line Programming (Basic)
Refer to your Software Manual for additional options for setting up Tie Line trunk and operator access.
If you don’t have a T1 Tester, you can alternately test Tie Line operation between two T1 PCBs in the same
cabinet or facility using the cable shown below (Figure 2-16).
Figure 2-16: Connecting Two T1 PCBs Together without a Telco T1 Circuit
(For Tie Line Testing)
Pin
Latch
faces up
To T1 PCB To T1 PCB
80061 - 3
1
2
3
4
5
6
7
8
RX1T
RX1R
TX1T
TX1R
TX1R
TX1T
RX1R
RX1T
Pin
8
7
6
5
4
3
2
1