User Manual

User may change any of the IP settings by simply typing in the desired address. Remember that if
User change the IP address of the device to an address that is outside the subnet of the computer
User are using, User will lose access to the SNMP Utility
• IP Address Internet Protocol address of the Access Point.
• Subnet Mask: Four sets of three digits used to logically divide an IP network into
sub-networks.
• Default Gateway: IP address of a gateway device necessary for communication with devices
outside the subnet of the Access Point. If User network is not divided into different subnets, this
can remain blank.
DHCP:
The Access Point can be configured as a DHCP client by choosing Enabled in the DHCP enable
pull-down menu. By default, DHCP support is disabled. If the Access Point is configured as a
DHCP client, it will be necessary to decide what media will be used to transport DHCP information
to the device. By default the Access Point is configured to receive IP settings through the
Ethernet port.
3.4.1 Change Password
User can change administrator password by Clicking on ”Change Password”. Please type new
password and click ”OK”.
Click “Save setting”
3.4.2 Encryption (WEP)
15