Specifications

XPEED Indoor Series WWW.CNBTEC.COM
3. Operation
⊙ Preset
• Function Max. 127 positions can be stored as Preset position. The Preset number can be assigned from 1 to 128, but 95 is reserved for
starting OSD menu.
Camera characteristics (i.e. White Balance, Auto Exposure) can be set up independently for each preset. Label should be blank
and Relay Outputs should be set to OFF as default. “Camera Adjust” should be set “GLOBAL” as default. All characteristics can
be set up in OSD menu.
• Set Preset <Set Preset> [1~128]
• Run Preset <Go Preset> [1~128]
• Delete Preset To delete Preset, use OSD menu
⊙ Swing
• Function By using Swing function, you can make camera to move between 2 Preset positions repeatedly.
When swing function runs, camera moves from the preset assigned as the 1st point to the preset assigned as the 2nd point
in CW(Clockwise) direction. Then camera moves from the preset assigned as the 2nd point to the preset assigned as the 1st
point in CCW(Counterclockwise) direction.
In case that the preset assigned as the 1st point is same as the preset assigned as the 2nd point,
Camera turns on its axis by 360° in CW(Clockwise) direction and then it turns on its axis by 360° in
CCW(Counterclockwise) direction. Speed can be set up from 1°/sec to 180°/sec
• Set Swing To set Swing, use OSD menu
• Run Sing Method 1) <Run Pattern> [Swing NO.+10] → ex) Run Swing 3 : <Run Pattern>[13]
Method 2) <Go Preset> [Swing NO.+140] → ex) Run Swing 3 : <Go Preset>[143]
• Deleting Swing To delete Swing, use OSD menu.
⊙ Pattern
• Function Pattern Function is that a camera memorizes the path (mostly curve path) by joystick of controller and preset move functions
for assigned time and revives the path exactly as it memorized.
4 Patterns are available and Maximum 1200 communication commands can be stored in a pattern.
• Setting Pattern Pattern can be created by one of following two methods.
Method 1) <Set Pattern> [Pattern NO.]
- Pattern editing screen is displayed as bellow.
- Movement by Joystick and preset movement can be
memorized in a pattern.
- The rest memory size is displayed in progress bar.
- To save the recording, press NEAR key and to cancel, press FAR key.
Method 2) Using OSD Menu : See the section “how to use OSD Menu”.
• Run Pattern Method 1) <Run Pattern>[Pattern NO.] → ex) Run Pattern 2 : <Run Pattern>[2]
Method 2) <Go Preset>[Pattern NO.+130] → ex) Run Pattern 2 : <Go Preset>[132]
• Delete Pattern Use OSD menu to delete a Pattern.
17