Specifications

XPEED Indoor Series WWW.CNBTEC.COM

2. Installation

■ Sensor Input/Relay Output

• Sensor input connection

Before connecting sensors, check driving voltage and output signal type of the sensor.

Since output signal types of the sensors are divided into Open Collector and Voltage Output type in general, the cabling must be done properly after

considering these types.

Also, the sensor type, i.e. “Normal Open” or “Normal Close” in DIP switch in main body of camera must be set properly.

Signal Line Description

IN COM+ Connect(+)cable of electric power source for sensors to this port as shown in the

circuit above.

IN1 -, IN2 -, IN3 -, In4 - Connect output of sensors for each port as shown in the circuit above.

• Relay output connection

Maximum allowable electrical load of relay is shown bellow table.

Driving Power DC 110VAC 220VAC

Max. Capacity 28VDC, 3A 110VAC, 3A 250VAC, 3A