Datasheet

XNET Network Box Camera User’s Guide
ii. If you have standard power connect the network camera and PC as illustrated in Figure
2.6.
Figure 2-6. Connecting Network camera and PC using AC Adaptor
② Install “IP installer” and “XNET-NVR” on your PC
Detailed information for installing these software can be found in [IP-Installer User’s
Guide] and [XNET-NVR User’s Guide] respectively.
③ Assign IP address to XNET/XNET-Wireless using IP installer
Identify the type of the network environment and set up IP address. Detailed process of
setting up IP address can be found in [IP-Installer User’s Guide]. If network type is xDSL or
Cable modem you need supplementary information provided by your ISP.
④ Connect to the XNET in Administrative Mode for initial parameter set-up
All parameters are set to factory default state when XNET/XNET-Wireless is delivered. You
are asked to configure the system for your environment in administration mode. Detailed
information of using administration mode can be found in [5. Configuring XNET/XNET-
Wireless in Administrative Mode]. Among the parameters, the parameters in the
following table should be set-up with proper values. Detailed information for the parameters
in Administrative Mode is found in [5. Configuring XNET/XNET-Wireless in
Administrative Mode]
[Note]: Set-up values are preserved even the power is turned off.
The table below shows the Administrator Mode’s parameters list.
XNET
DC I
n
LAN Hub
100BaseT
AC Adaptor
AC In
PC
The XNET Series does not support standard PoE. Do not connect the network
camera directly to a hub supporting standard PoE. We assume no
responsibility for the damages caused by use of standard PoE device with
this product.
10 of
47