User`s manual

Installing the Software and Running Your First Backup

5. Click on the Install button to start the install process. You may also view the manual,

uninstall existing software or check for upgrades from this screen.

6. You are required to authenticate your access to the system by entering your user

name and password.

7. Read license and click Accept.

8. After installing, a restart will be required so the BounceBack driver may be loaded. All

applications should have been closed before starting any installation, any that are

open will be closed for you.

9. Once your system reboots, the BounceBack software has been installed. To continue,

see Running Your First Backup.

NOTE: BounceBack software is installed in the Applications folder. Do not

move or install the software to any other folder.

Running Your First Backup

Once the software installation is complete and your system has rebooted, the

BounceBack software will begin to configure your first backup.

1. After the operating system reboot, you will be requested to register your BounceBack

software through a link to a registration web site.

2. After registration, the software has to be activated by entering an activation code.

The code is supplied with the BounceBack software, usually on the flap of the

BounceBack CD cover, and consists of 4 groups of 5 characters.

3. During the setup process, you will be prompted to determine the target location of

your back up data.

4. Click Yes to use a second internal hard drive or external drive as the backup device.

Click No to direct the backup to your primary hard drive.