Specifications

87
July 08 XYZ Machine Tools Issue 01
XYZ 560 Mini Mill and 710 VMC Operation Manual
3. Press the Auto switch to select Auto mode.
4. Secure the workpiece.
5. Push the cycle start button to start the process.
6. If an emergency occurs, push the feed hold button or the emergency stop button.
6.12 Switching Off Procedure
1. To power down the Machine, press the E-stop on the pendant.
2. Switch off the main power supply switch located on the electrical cabinet wall.
3. Isolate the Machine at the isolator.
6.13 Post-operation Maintenance
1. Make sure all components of the Machine are in good working order.
2. Check the centralized lubrication system and if necessary, fill the oil tank with the correct
oil, refer to
Section 8.3.4.
3. Make sure no leakage has occurred in the pipelines.
4. Make sure all screws are secure.
5. Make sure all gauges and indication meters are in good working order.
6. Clean the Machine and work area.
6.13.1 Notices
1. Switch off the power supply of the Machine and put ‘Under Maintenance. Do not switch
on the power supply’ warning signs in visible locations.
2. Clean the Machine and the work area. Put all items in their correct position.
3. Apply anti-rust oil to the machine bed and all moving parts to protect from rust and dirt.
4. Return the moving parts of the Machine to the original zeroing position.
5. Check the wipers and replace if broken.
6. Check the lubricant and hydraulic oil and replace if dirty or emulsified.
7. Check the coolant and replace if dirty.
8. Check the lubricant, hydraulic oil and coolant and refill if necessary.
9. Clean the filters of the lubrication, hydraulic, and coolant systems.
10. Switch off all power switches and main power circuit breakers.