Specifications

78
Issue 01 XYZ Machine Tools July 08
XYZ 560 Mini Mill and 710 VMC Operation Manual
14. Wear a safety mask and open the dust collecting equipment when machining a
workpiece made from graphite or other materials which create dust.
15. Do not open the safety guard doors when operating the Machine.
16. Monitor the swarf build-up during machining and make sure the build-up does not
become excessive.
6.7 Referencing the Machine
1. Stop all machine movements.
2. Push the ‘Stop’ button on the NC equipment, refer to Figure 50.
3. Switch off the main power supply switch.
6.8 Manual Operation Procedure
6.8.1 Manual Operation Mode
Set the mode select switch to JOG mode to enable manual operation mode, refer to Figure 52.
Note - Setting the mode select switch to manual mode will interrupt the automatic
operation process. The manual operation will stop if any mode other than manual
mode has been selected.
6.8.2 Manual Feed Motion
1. Set the mode select switch to JOG mode to enable the manual feed motion, refer to
Figure 52.
2. Adjust the feedrate, refer to Figure 53.
3. Select the axis to feed (X, Y or Z).
4. Push the + or - button to start the feed motion. With the button pushed, the feed motion
will continue and when the button is released the feed motion will stop, refer to
Figure 53.
6.8.3 Manual Rapid Traverse Feed
1. Set the mode select switch to JOG mode to enable the manual rapid traverse feed, refer
to
Figure 52.
2. Push the rapid traverse speed button and select the feed direction to start the manual
rapid traverse feed. The feed movement will stop when the rapid traverse speed button
is released, refer to
Figure 53.
6.8.4 MPG Feed Motion
1. Set the mode select switch to JOG mode, refer to Figure 52.
2. Use the MPG scale select to set the correct speed and select the motion direction, refer
to
Figure 52.
3. Use the hand wheel to control the feed motion. Press dead mans button on back of hand
wheel.