Specifications

77
July 08 XYZ Machine Tools Issue 01
XYZ 560 Mini Mill and 710 VMC Operation Manual
6.5 Preparation
6.5.1 Safety Precautions
1. Use the correct cutting tools.
2. Do not use broken or defective cutting tools.
3. Make sure the work area has adequate lighting.
4. Keep the tools and equipment around the Machine in position.
5. Keep the Machine and the work area clean.
6. Do not put any items on the work surfaces, headstock, working tables, guideways,
saddle or safety guards.
6.5.2 Notices
Caution - Before switching on the power supply, make sure the load capacity is
correct.
1. Make sure the alarm indicator messages are off before operating the Machine.
2. Check the oil level of the oil tank regularly. If necessary, fill the oil tank with the correct
oil, refer to
Section 8.3.4.
3. Use the correct cutting tools.
4. Test the Machine with a trial test piece before normal operation.
6.5.3 Alarm messages
1. Refer to alarm message page.
6.6 Operational Safety Precautions
1. Keep long hair and loose clothing away from the rotating parts of the Machine.
2. Do not wear gloves when operating the Machine.
3. Use appropriate manual handling techniques to handle large workpieces.
4. The forklift, crane and lifting equipment must be operated by qualified personnel.
5. Use the correct lifting equipment.
6. Be careful of the surroundings when operating the lifting equipment.
7. Make sure the workpiece is correctly clamped in the holding device before operating the
Machine.
8. Stop the Machine before adjusting the coolant nozzles.
9. Do not touch or reach over moving or rotating machine parts.
10. Do not remove any safety equipment.
11. Use the correct tools to remove the debris from the cutting tool.
12. Stop the Machine before installing or removing the cutting tool from the chuck or other
tool holding equipment.
13. Wear appropriate personal protective equipment when working in a dusty environment.