Specifications

76
Issue 01 XYZ Machine Tools July 08
XYZ 560 Mini Mill and 710 VMC Operation Manual
8. The Rotary Tool Changer gear speed reduction motor power is 220 V/60 Hz, 200 V/50
Hz.
9. An additional air filter should be installed in the Rotary Tool Changer to remove
unwanted substances and water.
10. Regularly grease the contact faces of the Rotary Tool Changer tool pockets.
6.3 Starting and Stopping the Machine
6.3.1 Starting Procedure
1. Connect the power supply.
Caution - Before switching on the power supply, make sure the load capacity is
correct.
2. Switch on the main power supply switch.
3. To switch on the main power:
• Switch on the main power supply.
• Switch on the isolator. Press reset.
• Press the servo on button, located on the side of the pendant.
• To reference the machine, press the cycle start button (ensure feed overrid is on
100%).
Note - Make sure the standby signal light is on after switching on the main power supply.
6.3.2 Emergency Stop Procedure
Push the emergency stop button on the main operation panel to stop the machine immediately.
Pull the emergency stop button to release, refer to
Figure 52, and then press reset and servo
on.
6.3.3 Normal Stop Procedure
1. Stop all machine movements.
2. Push the ‘Stop’ button on the NC equipment, refer to Figure 50.
3. Switch off the main power supply switch.
6.4 Warm Up
Prior to the operation of the Machine, warm up the machine, as the sudden thermal expansion
of the casting parts can damage the contact surfaces of the sliding parts.
6.4.1 Notices
1. Warm up the Machine in automatic mode for 10 to 20 minutes by running a program.
Make sure the Machine has an appropriate spindle speed and feed rate.
2. Make sure the Machine is operating correctly during the warm up of the machine in
automatic mode.