Specifications

63
July 08 XYZ Machine Tools Issue 01
XYZ 560 Mini Mill and 710 VMC Operation Manual
Figure 40 Adjusting the square between the spindle centreline and the working table
5.4.3 Adjust the Square Along the X, Y, Z Axis
1. Prepare the dial gauge set and square rule.
2. Position the square rule on the working table.
3. Fix the dial gauge set directly under the spindle, refer to Figure 41.
4. Move in the X, Y and Z direction to level the machine until the readings at both ends are
the same.
5. Measure the square along the three axes.
6. If the values are over the standard value, adjust the leveling screws.
xyz-050