Specifications

31
July 08 XYZ Machine Tools Issue 01
XYZ 560 Mini Mill and 710 VMC Operation Manual
3.1.6.2 Tool Clamping and Unclamping Mechanism
The disc spring applies a clamping force of approximately 800 kgf. To grip the tool holder, the
draw bar is pulled up by the disc spring set which pulls the tool retention knob upwards. To
release the tool, the retention knob is released pneumatically. A stream of compressed air
blows through to clean the taper hole and tool.
Figure 21 Tool clamping and unclamping mechanism
xyz-079
DISC SPRING