Specifications

July 08 XYZ Machine Tools Issue 01

XYZ 560 Mini Mill and 710 VMC Operation Manual

37. Do not leave tools in the machine during setup.

38. Do not reach over, under or around a workpiece to make an adjustment when the

spindle and workpiece are in motion.

39. Do not reach over, under or around a workpiece to retrieve any item.

40. Do not reach over, under or around a workpiece to tighten a machine part.

41. Do not reach over, under or around a workpiece to move a hand tool to a different

position.

42. Do not reach over, under or around a workpiece to remove swarf.

43. Understand the correct procedure for applying loads. Do not apply force from a difficult

position.

44. Do not install a workpiece which is too large for the machine.

45. Do not install a workpiece, which is too large for the operator to handle, without lifting

equipment.

46. Use the correct equipment for handling workpieces.

47. Secure all workpieces.

48. Secure all jaws, nuts, bolts and blocks.

49. Use the correct equipment.

50. Do not take cuts more than the machine’s capability.

51. Use the correct hand tool to remove swarf.

• Do not rush to remove swarf.

• Be careful of swarf wrapped around the spindle or workpiece.

52. Do not change the original setting parameters unless instructed by XYZ Machine Tools

personnel. Keep a record of the original setting values before change.

53. Do not block or remove any warning signs or information plates. Please contact XYZ

Machine Tools or our local dealer to purchase replacement signage if they become

damaged.

54. Disconnect the isolator of the main power immediately if the power supply is unstable.

2.3.7 Safety Precautions for Operating the Centralized Lubrication

System

2.3.7.1 Prior to Installation.

• Prior to installation of the centralized lubrication system, refer to Section 5.6.1 of this

manual for the correct connection of the power.

• Make sure the correct electrical specification is adhered to.

• Do not use the centralized lubrication system for any other function except lubrication of

the machine with oil.