Specifications
18
Issue 01 XYZ Machine Tools July 08
XYZ 560 Mini Mill and 710 VMC Operation Manual
11. Remove oil and grease from hand tools, levers and handles.
12. For safe operation, make sure there is enough texture on the surface of the hand tool or
lever handle.
13. Hold hand tools and lever handles correctly.
• Always select the correct hand tool and applicable grip position on the lever handle.
• Do not use hand tools or lever handles in difficult positions.
• Do not apply excessive force to hand tools or lever handles.
14. Hold hand tools and lever handles in the recommended holding position.
15. Do not use broken, chipped or defective tools.
16. Make sure the workpiece is correctly clamped in a vice or other holding device.
17. Be careful of irregular workpieces when clamping.
18. Be careful if large burrs exist on workpieces.
19. Select the correct tool for the job.
20. Wear gloves when handling a sharp tool.
21. Pay attention when changing the tool to ensure the tool is not dropped.
22. Do not leave the machine unattended.
23. Do not use tools without handles.
24. Do not rush when operating the machine.
25. Do not use alternative tools if the correct sized tool is not available or cannot be located
in the workshop.
26. Do not open the guards while the machine is in operation.
27. Do not put any part of your body in the path of moving objects.
• Be careful of moving machine parts that can fall.
• Make sure you are aware of where you are moving your hands or body in relation to
the machine.
• Make sure your hands or other parts of the body are not in a position to be hit by
the spindle or workpiece.
28. Understand the function of all controls.
29. Do not put your hands on a spindle or workpiece when it is in motion.
30. Make sure power is isolated when the machine is not in use.
31. Do not start the spindle with the tool key in the tool.
32. Do not get distracted when operating the machine.
33. Be careful of machine hazards when attending to other features of machine operation.
34. Keep long hair and loose clothing away from the rotating parts of the machine.
35. Make sure the spindle is not in operation when using gauges on the machine.
36. Be careful of material and tool ejection from the machine.