Specifications

16
Issue 01 XYZ Machine Tools July 08
XYZ 560 Mini Mill and 710 VMC Operation Manual
2.3.4.2 Variable Speed Drive
The machine is designed to allow fast and easy change of the spindle speed. Make sure the
workpiece is secure and the maximum safe speed for the operation is not exceeded by setting
the MAX RPM for each job.
2.3.4.3 Hazardous Areas
Keep away from the areas which have moving or rotating machine parts. Do not touch or reach
over moving or rotating objects. The moving or rotating parts are shielded by guarding doors
or covers and will cause serious injury if not used correctly. Understand the safety procedures
before you use the machine. Be aware of potentially dangerous areas and obey warnings to
avoid injury.
2.3.4.4 Machine Safety Guard
The machine is equipped with a fully-enclosed sheet metal enclosure guard. These guards are
interlocked through the machine logic to all essential Health and Safety requirements of the EC
Machinery Directive, necessary for CE marking.
WARNING - The machine is equipped with safety devices. Do not modify any safety
devices on this machine. If modifications to these safety devices are made, XYZ
Machine Tools will not be responsible for any issues of product liability. Any changes
will also invalidate any remaining warranty entitlement.
2.3.5 Operational Safety Precautions
1. Do not use the machine without adequate lighting, or if the machine light is broken.
2. Clean any spillages from oil coolant etc., to eliminate slip hazards.
3. The floor area can become hazardous if water or oil is spilled. Make sure the floor is
clean, dry and free from contamination.
4. Keep the machine and work area clean and tidy.
5. Make sure you have sufficient working space.
6. Keep all guards and cover plates in position and all machine cabinet doors closed.
7. Keep the working surfaces of the machine clear, where moving or rotating parts could
make contact.
8. Do not touch or reach over moving or rotating machine parts.
9. Operate all switches carefully.
10. Before use, make sure you understand the function of each switch and how to use it.
11. Do not operate the machine in excess of its rated capacity.
12. Stop the machine immediately if anything unusual occurs.
13. Make sure you understand how to stop the machine before starting it.
14. Eye protection must be worn by all exposed persons and the operator of the machine.
Do not rely on the Lexan Vision Panels for eye protection.
15. Reset the coordinates before operating the machine. It is not necessary to reset the
common coordinates when personnel share the machine operation.
16. Electrically isolate the machine when leaving it unattended.