Specifications

100
Issue 01 XYZ Machine Tools July 08
XYZ 560 Mini Mill and 710 VMC Operation Manual
3. Make sure all electrical components, such as connectors, switches and cables, are in a
good, serviceable condition.
4. Check and record the insulation resistors.
5. Make sure the tool exchanger does not obstruct the spindle.
8.5.5 Yearly Maintenance
1. Make sure the push buttons and switches on the control panel operate correctly.
2. Remove the carbon deposits from the electrical relay points. Clean the electrical relay
points with isopropanol cleaning solvent.
3. Make sure the balance chains are in a good, serviceable condition.
4. Clean the hydraulic system, including the oil tank. When clean, fill the oil tank with the
correct oil and make sure the pressure settings are correct.
5. Check the machine level and adjust if necessary. For machine levelling, refer to
Section 5.4.
6. Make sure all electrical wire connections are secure.
7. If necessary, replace the oil in the spindle cooler system.
8.5.6 Three Yearly Maintenance
1. Lexan vision panels should be replaced every three years as their impact resistance
deteriorates with age.
8.6 Rotary Tool Changer Maintenance
8.6.1 To Remove a Tool from the Rotary Tool Changer
1. Put the wrench (M08) between the tool pocket and the tool. Refer to Figure 64 and
Figure 65.
2. Push the wrench forward to withdraw the tool from the tool pocket.