Specifications
99
July 08 XYZ Machine Tools Issue 01
XYZ 560 Mini Mill and 710 VMC Operation Manual
2. Do not use compressed air to remove debris from the machine, especially to
remove swarf from the slideways.
3. Remove the anti-moisture substances from the enclosures.
4. Clean the Machine and the work area. Put all items in their correct position.
5. Contact XYZ Machine Tools if any incorrect conditions are found during maintenance. Do
not disassemble the Machine.
8.5 Preventative Maintenance
To keep the Machine in a good serviceable condition, follow the maintenance procedures in this
manual.
8.5.1 Daily Maintenance
1. Make sure the quantity of oil in the centralized lubrication system is sufficient.
2. Make sure the quantity of cutting fluid in the fluid tank is sufficient.
3. Clean the Machine and work area after use. Apply a layer of rust-preventative oil to the
exposed sliding surfaces.
4. Switch the power source off after use.
5. Release the water collected in the air filter cap.
6. Remove swarf from the Machine after use.
7. Check the spindle taper bore after use. Clean the spindle taper bore with the spindle
taper bore cleaner.
8. If any problems occur, stop the Machine immediately and find the source of the
problems.
9. Make sure no unusual noise occurs when the Machine is in operation.
10. Check and report any damage to vision windows.
8.5.2 Weekly Maintenance
1. Make sure all the pumps operate correctly.
2. Make sure the tool exchange system operates correctly.
3. Make sure the swivel disk of the tool magazine rotates correctly.
8.5.3 Monthly Maintenance
1. Check the gibs on the bed and cross slide. If necessary, adjust the gibs, refer to
Section 7.2, Section 7.3 and Section 7.4.
2. Clean the cutting fluid pipes and lubrication oil pipes.
3. Clean the cutting oil tank and fill the tank with the recommended oil.
4. Check and clean the ballscrews.
5. Make sure all nuts and screws are secure.
8.5.4 Half Yearly Maintenance
1. Make sure the spindle run out and bearing clearances are within specification.
2. Make sure all nuts and screws are secure.