Specifications

Issue 01 XYZ Machine Tools July 08

XYZ 560 Mini Mill and 710 VMC Operation Manual

7.8 Adjustment of the Rotary Tool Changer Arm

To do the adjustment of the arm on the rotary tool changer:

1. Push the clutch link down, refer to Figure 63.

2. Use the wrench to rotate the motor.

3. Turn the arm to the angle of the set up edged tool, refer to Section 6.10.4, Figure 54.

4. Adjust the arm to hold the edged tool.

5. Tighten the setup screws.

Figure 63 Adjustment of the rotary tool changer arm

xyz-024

Wrench

Clutch link

Motor

Arm

Rotate