Specifications

Issue 01 XYZ Machine Tools July 08

XYZ 560 Mini Mill and 710 VMC Operation Manual

7.5 Adjustment of the Square Between the Spindle Centre Line

and the Table Surface

1. Set and hold the dial gauge directly under the spindle, refer to Figure 59.

2. Make sure the distance between the dial gauge probe and spindle center line is 160 mm.

3. Move the headstock along the Z direction until the dial gauge probe touches the working

table surface.

4. Rotate the spindle and measure the value.

5. If any value is over the standard value, adjust the Machine.

Figure 59 Adjusting the square between the spindle centre line and the working table

xyz-050