Installation Guide

The manufacturer warrants that the parts and assemblies of this prodcut will be free from defects in material and
workmanship under normal household use for 5 years as it is owned by the original consumer purchaser.
This warranty covers the original purchaser with original receipt only and does not include business, commerical, or industrial
use of this product. This warranty shall not apply to goods which have been subject to accidents, negligence, or improper
installation. Our responsibility under this warranty is limited only to the replacement of parts and no other costs. Should a
malfunction occur within the time covered by this warranty, replacement parts may be obtained from Customer Service
Department 1-800-626-3525 or email [e-mail]. The manufacturer will, at its discretion, provide replacement
parts for installation by consumer for any parts that prove defective under normal usage and care with new or equivalent parts.
1. Remove the lock nut (#7), large washer (#6),
and small washer (#5) from the stopper housing
(#4).
Please Note: Before installation, verify there is no
damage to the drain. If there is damage, call customer
service for a replacement. Do NOT install damaged parts.
2. Remove the old drain assembly. Clean the surface to
remove the old adhesive and dirt before installing the
new drain. Dry the area thoroughly.
3. Place a ring of silicone sealant around the small
washer (#5) on the stopper housing (#4) or the
drain opening of the sink. Insert the stopper housing
(#4) into the drain hole from the top.
4. From underneath the sink, slide the large washer
(#6) onto the stopper housing (#4), then screw
on the lock nut (#7) hand tight. Do not over tighten.
See the diagram for a visual. Please continue to
complete the drain installation.
5. Close the drain and fill the sink with water. Check
for leaks. If water is leaking from the drain, refer
to steps 1-4 or tighten the area where the leak
is occurring.
01/07/2022