Installation Guide

Faucet Installation
3. 4.
5. 6.
“HOT”corresponding
to hot water
11
10
13
6
17
3
2
1
16
9
8
7
12
3. Install the cartridge 7 , cartridge sleeve 8 and cartridge locknut 9
into the valve body.
4. Close bathtub drain to avoid losing parts. Install escutcheon 6 and
secure it with escutcheon screws 13 and escutcheon screw
o-rings 17 . Make sure valve is in off position. Then assemble the
handle 10 and secure it with set screw 11 .
5. Apply teflon tape to two ends of shower arm 2 and install it to wall
with shower arm flange 1 . And connect the shower head 3 to
shower arm 2 .
CAUTIONS:ENSURE THE RUBBER WASHER IS IN POSITION BETWEEN
THE SHOWER HEAD AND SHOWER ARM.
6. Position the tub spout 12 as shown, adjust it and fix it with Allen
Key 16 .
Turn on water and check for leaks. If there are leaks, please reinstall.