Installation Guide

Faucet Installation

1. For tub spout installation only: install copper pipe for spout, use

proper length copper pipe so that the pipe will extend 1-1/2”~3”

from the finish wall.

In order to assure proper function, piping from the bottom port of

valve to tub spout outlet must be either 1/2” nominal copper pipe or

1/2” iron pipe.

2. Remove the locknut sleeve, O-ring and test plug as shown.

Note: DO NOT DISCARD locknut sleeve. This item is used to secure

cartridge.

1. 2.

1-1/2”~3”