Installation Guide

A. B. C.

Warning:

The supply valves and

supply lines are not

included.

1. Remove old drain assembly. Clean all sink surfaces

to remove old putty and dirt before installing new drain.

Disassemble new pop-up assembly: remove nut 31 ,

outlet pipe 30 , washer 29 , locknut 28 , washer 27 and

washer 26 .

If the faucet is installed in a sink with overflow,

follow step 2. Otherwise, please skip to step 3.

2. Unscrew the cover 22 counterclockwise by hand.

Unscrew the stopper core 24 counterclockwise with

proper tool. Replace the original stopper housing

without overflow hole 25 by the new stopper housing

with overflow hole 32 . And assemble the stopper

core 24 , cover 22 . Continue to step 3.

3. Place a ring of silicone sealant around the

washer 26 or the drain opening of the sink.

Insert stopper housing 25 with washer 26

through the drain hole.

4. Install washer 27 to the stopper housing

25 , then hand tighten the locknut 28 , but do

not over tighten. See diagram for visual.

5. Position washer 29 into outlet pipe 30 , attach

nut 31 onto outlet pipe 30 , and then hand

tighten nut 31 , but do not over tighten. See

diagram for visual.

Hint-Outlet 30 is used to connect to the p-trap

drain-please refer to those installation instruction

for assembly.

Let both hot and cold water run for one minute. This will

help clean any debris that might clog the system.