Installation Guide

ManualsBrandsCMI ManualsBathroomCardania Brushed Nickel 1-Handle Single Hole WaterSense Bathroom Sink Faucet with Drain

Model No. : 192-6410 Polished Chrome

Cardania Single Handle Vessel Faucet

With Dual Function Pop-up Drain

Single Hole Installation works with overflow or

no overflow bathroom sinks

Revised 4/22/17

In the event that Freendo faucets are used in a Commercial Application, this warranty is limited for

a period of 5 years, unless otherwise specifically stated in the catalog and/or price book.

repair. Compass Manufacturing International will, at its discretion, provide new or equivalent replacement

parts for any product that proves to be defective under normal usage and service.

192-6411 Brushed Nickel

192-6412

Oil-Rubbed Bronze

Summary of content (4 pages)

PAGE 1
Model No. : 192-6410 Polished Chrome 192-6411 Brushed Nickel 192-6412 Oil-Rubbed Bronze In the event that Freendo faucets are used in a Commercial Application, this warranty is limited for a period of 5 years, unless otherwise specifically stated in the catalog and/or price book. repair. Compass Manufacturing International will, at its discretion, provide new or equivalent replacement parts for any product that proves to be defective under normal usage and service.
PAGE 2
and/or Silicone 32 Stopper Housing(With Overflow Hole) 31 Nut 30 Outlet Pipe 29 28 Washer Locknut 27 Washer 26 Washer 25 Stopper Housing(Without Overflow Hole) 24 Stopper Core 23 Washer 22 Cover 21 Aerator Wrench 20 Allen Key 19 Adapter 18 O-ring 17 Set Screw 16 Waterway 15 Screw 14 Locknut 13 Clamp 12 Shank 11 O-ring 10 Body 9 Aerator 8 O-ring 7 O-ring 6 Cartridge 5 Cartridge Locknut 4 Trim Cap 3 Index 2 Set Screw 1 Handle No.
PAGE 3
Faucet Installation 1 2 3 4 16 5 6 17 20 7 8 21 11 9 22 23 24 10 14 32 11 18 19 12 13 25 15 26 27 28 29 30 1. Position the faucet in order on the countertop as shown. Don't forget the O-ring 11 . 13 31 14 15 2. Assemble clamp 13 and locknut 14 to faucet shank by hand and tighten the screws 15 with the screwdriver.
PAGE 4
1. Remove old drain assembly. Clean all sink surfaces to remove old putty and dirt before installing new drain. Disassemble new pop-up assembly: remove nut 31 , outlet pipe 30 , washer 29 , locknut 28 , washer 27 and washer 26 . 30 B. C. Warning: The supply valves and supply lines are not included. 31 If the faucet is installed in a sink with overflow, follow step 2. Otherwise, please skip to step 3. 2. Unscrew the cover 22 counterclockwise by hand.