Installation Guide

rod guide nut 43rod ball
plastic
gasket 42
drain
stopper
hole
drain
body 39
o-ring
sink
drain stopper 33
flange 34
align hole in
drain stopper
with guide rod
opening
(pointed toward
back wall)
flange 34
drain body 39
top rubber washer 35
sink base
locknut 38
washer 37
bottom
rubber
washer 36
tailpiece 40
lift rod 46
faucet
body
A. Remove pop-up drain stopper 33.
and flange 34 with top rubber
washer 35 for pop-up assembly.
B. Insert drain body from underneath
of sink drain hole.Replace flange 34
and top rubber washer 35 back to
drain body 39 .Tighten flange as far
as possible.
C. Slide bottom rubber washer 36
on drain body up against bottom
of sink. Tighten washer 37 and
locknut 38 firmly against base
for tight seal.
D. Remove tailpiece 40 from drain
body 39 ,add teflon tape,replace
tailpiece 40.
A. Replace pop-up drain stopper 33
to drain body 39 with o-ring
in place, and align stopper hole
with guide rod opening.
A. Remove rod guide nut 43 and
rod ball plastic gasket 42 .
B. Insert horizontal rod 41 into
drain body 39 and through hole
in drain stopper 33 .
C. Replace rod guide nut 43 with
rod ball plastic gasket 42 and
tighten it.
horizontal rod 41
extend rod 45
horizontal rod 41
spring
clip 44
extend rod
hole
extend rod
screw 32
A. Insert lift rod 46 through hole on
faucet body. Connect horizontal
rod 41 to extend rod 45 using
spring clip 44 to hold and adjust.
B. Attach extend rod 45 with
lift rod 46 by inserting lift rod
through extend rod hole. Now
adjust lift rod 46 to correct height
and hand tighten extend rod
screw 32 .