Compass @ Manufacturer ATONAL Overspends fondants LIMITED LIFETIME WARRANTY Compass Manufacturing International warrants to the original consumer purchaser that the faucet be free from defects In material and workmanship for 2s long as the original consumer purchaser owns the home in which the faucet was first installed. In the event that Doreen faucets are used n a Commercial Application, this warranty s lifted for overload of 5 years, unless otherwise specifically stated In the catalog and/or price book.
Helpful Tools Tools: Gather the necessary tools as shown below to complete the installation of this faucet. Some may not be needed depending on the model of faucet you are installing. Plumber's Putty Basin Wrench Safety Glasses and/or Silicons Adjustable Wrench Flashlight Screwdriver Pullers Channel Locks Maintenance Your new faucet is designed for years of trouble-free performance. Keep It looking new by cleaning It periodically with a soft, damp sloth.
4 A. Faucet Shank B Faucet Shank C Faucet Shank : Connect to water supply lines with either: 0.D. Copper tubing (ball nose risers with the coupling nuts or; Copper tubing (no ball) with supplied tube head interior connector or; {C) IPS faucet connectors (12") Warning: The supply lines are not included. Important: Remove the aerator assembly using the aerator wrench (#18) provided. Turn on the hot and cold water for one minute. This will flush any debris from the lines that might clog the system.
. Shut off the water supplies before installation. Remove the current faucet. Clean and dry the surface the new faucet will be installed on. . Unscrew the lock nuts (#16) from the brazed under body . Place silicone sealant beneath the gasket (#15) and insert the under body (#13) through the faucet holes. . Screw the lock nuts (#186) onto the under body (#13) hand tight. Do NOT over tighten. Hint: Have someone hold the deck plate (#9) in place while tightening.
