Installation Guide

3
2
rod guide nut 30rod ball
plastic
gasket 29
drain
stopper
hole
drain
body 26
o-ring
sink
drain stopper 20
flange 21
align hole in
drain stopper
with guide rod
opening
(pointed toward
back wall)
flange 21
drain body 26
top rubber washer 22
sink base
locknut 25
washer 24
bottom
rubber
washer 23
tailpiece 27
A. Insert lift rod 11 through hole
on faucet body.
B.Connect extend rod 32 to lift
rod 11 .Attach horizontal rod 28
to extend rod 32 using fittings 31,
tighten screw.
lift rod 11
faucet
body
extend rod 32
horizontal rod 28
screw
fittings 31
A. Replace pop-up drain stopper 20
to drain body 26 with o-ring
in place, and align stopper hole
with guide rod opening.
A. Remove rod guide nut 30 and
rod ball plastic gasket 29 .
B. Insert horizontal rod 28 into
drain body 26 and through hole
in drain stopper 20.
C. Replace rod guide nut 30 with
rod ball plastic gasket 29 and
tighten it.
horizontal rod 28
drain
body 26
A. Remove pop-up drain stopper 20.
and flange 21 with top rubber
washer 22 for pop-up assembly.
B. Insert drain body from underneath
of sink drain hole.Replace flange 21
and top rubber washer 22 back to
drain body 26.Tighten flange as far
as possible. Remove 22 and put
silicone along bottom of 21 .(Optional)
C. Slide bottom rubber washer 23
on drain body up against bottom
of sink. Tighten washer 24 and
locknut 25 firmly against base
for tight seal.
D.Remove tailpiece 27 from drain
body 26 ,add Teflon tape,replace
tailpiece 27.