Instructions / Assembly

Installation Instructions
Inspection and Set-up
Check Valve set complete with the following:
- Cold Water Valve
- Hot Water Valve
- Pressure Relief Valve
1.Use and Installation Manual
a) Remove tank-less from packaging and inspect contents
b) Carefully position tank-less unit front face-up on floor or
blocks in a stable location for valve installation
2.Installing the valve set
a) Begin with applying approved thread sealant and/or Teflon
tape to the male threads on your tank-less unit
b) Next remove the hot water valve from packaging and hand
thread pipe nipple into the valve outlet
c) Use the pipe nipple as a handle and rotate valve handle a
couple of times to exercise it before installing
d) Gently thread hot water valve onto hot outlet of tank-less
heater, position of valve should face handle away from tank-
less unit when in the “Run” Position/ wrench tighten