User manual

Plugiator ASX User Manual

Changing PChanging P

Changing P

resetsresets

resets

Each plug-in on the Plugiator ASX has 100 internal presets.

Note: Note:

Note: Creating, storing, modifying and managing preset files will be discussed later

in this User Manual

There are two ways of changing presets for the currently active plug-in on the Plugiator

ASX.

1. Changing presets via the Plug-in Manager software installed on a PC. Note that

in this case, a preset which is stored in the software will be recalled. These presets

reside on your computer, and may not be related to presets stored in your Plugiator

ASX board.

2. Changing presets from your MIDI keyboard by sending MIDI Program Change

messages in the range of 1 to 100. This will call up the corresponding preset which is

stored in the Plugiator ASX board.

Note: Note:

Note: Presets which are stored in the Plugiator board are not nessesarily in sync with

presets listed in the Plug-In Manager Software. Changes you make in the software

will not be stored in the board unless you write the bank to the Plugiator hardware.

Vice versa, changes you make to the presets stored in the Plugiator board will not be

available in the software unless you read out a bank from the Plugiator board. That

was done on purpose to allow management of multiple banks across multiple Plugiator

boards.

MIDI PMIDI P

MIDI P

rogram Change Listrogram Change List

rogram Change List

MIDI Program change 1....100 Loading Presets.

MIDI Program change 101....108 + any Note Loading Plug-ins.

MIDI Program change 109....127 Have no effect.