User manual

Step 3:
Gently insert the Neosynth expansion board into the VX or UF keyboard and place the 4 respectively 5
screws to tighten the Neosynth expansion board.
Step 4:
The quickest way to be able to make sure your Neosynth is installed correctly is to plug in a headphone
in the NeoSynth’s headphones output and play the demo on your VX or UF keyboard (see the respective
VX or UF keyboard manual how to do that. On the VX press the expansion link button).
Another way is to attach one or two audio cables from your Neosynth to your DAW, computer or ampli-
fier to be able to hear the synth.
Attach a USB cable from your Neosynth to your computer to be able to edit instruments etc. with the pro-
vided patch editor software.
Step 5:
Power on the VX or UF keyboard. While doing that watch the back of the keyboard and see if the two leds
on the Neosynth expansion board lit up (one yellow and one red one should go on for a few seconds and
then go off again). When a USB cable is connected to your computer the red led will burn.
For more information about selecting the NeoSynth and choosing the various sounds please read the
manual provided with your VX/UF keyboard.
By now it should be possible to play and hear the sounds of the Neosynth.
NeoSynth inputs and outputs
Connections
The Neosynth expansion board has several connection possibilities to increase the use in all kinds of set-
tings (Grey NeoSynth: UF version, Red NeoSynth: VX version).
From left to right:
9