User`s manual

20
z When you press [Transpose] or [Octave], you will see the information as below:
O c t a v e : 0 0
T r a n s p o s e : 0 0
 When you change the Tranpose or Octave value, the corresponding button will
light on.
 The octave shift range is -04～00～+04 octaves. Pressing the two octave
buttons at the same time will reset the octave shift to 0, and the button will light
off.
 The transpose shift range is -12 ～ 00～ +12 semi-notes. Pressing the two
transpose buttons at the same time will reset the transpose shift to 0, and the
button will light off.
7.5 Knobs and faders
z When you adjust a knob or a fader, it will send MIDI data to a specific port and
channel.
z When you adjust a knob or a fader, the instrument will show information as below:
E N 1 : 0 6 4 C H : 0 0 P 1
C C : 0 7 3 - A T T A C K
 For the encoder knobs (ENCODER)1～9, it shows EN1～9 and the value.
 For the potentiometer knobs (KONB)1～8, it shows KN1～8 and the value.
 For the faders (SLIDER)1～9, it shows SL1～9 and the value.
 CH means channel. CH value KB means following the keyboard channel, value
01～16 means MIDI channel, value Z1-Z4 means using the Zone function.
 P means MIDI Ports. Port value 1～4 means the 4 MIDI OUT ports.
 CC means control change # and names. Refer to the appendix <Assignable
controller list> and <Note list>. You can move the cursor to the CC#, change its
value and confirm by pressing [ENTER].
7.6 Playing the pads
z When you play a pad, it will send MIDI data to a specific port and channel. The pads
are velocity sensitive.
z When you play a pad, the instrument will show information as below:
P a d : 0 1 V e l : 0 5 8
N o t e : 0 0 1 ( C # - 2 )
 Pad # range is 01～12.
 Vel means the velocity, and the range is 000～127.