User`s manual

5.3 Working with the joystick
z Move the joystick to the left/right to send the PITCHBEND message.
z Move the joystick upward to send CC#1 (MODULATION) message.
z Move the joystick downward to send the AFTER TOUCH message.
You can use the 【 ASSIGN JOYSTICK 】 command to define the downward
joystick message. (6.1) .
5.4 Pedal
z For the two pedal jacks, each one can be used for continuouls pedal (e.g volume
pedal) or switch pedal (e.g sustain pedal).
z By default, PEDAL A is for sustain pedal and send CC#64 message, the data value
is either 0 or 127(switch data); PEDAL B is for volume pedal and send CC#11
message, the data range is 0-127(continuous data).
z To change pedal type or polarity, please use the system settings function (7.2-7.3).
You can customize the MIDI data to be sent using the
【 ASSIGN PEDAL 】
command (6.3).
5.5 Selecting a voice
5.5.1 Bank MSB Select
z Operation：【SHIFT】ÖG1【Bank MSB Select】Ö【Set value】Ö【ENTER】
z MIDI message sent：CC#0 + CC#32 + Program
z Default value：0
z Value range：0-127
In the above operation,
【 SHIFT 】 means press the 【 SHIFT 】 button and its
indicator is on;
G1 【 Bank MSB Select 】 means press the G1 key in the
keyboard;
【 Set value 】 means using the number keys in the keyboard to enter
the value;
【 ENTER 】 means press the ENTER key in the keyboard.
Before use the 【 ENTER 】 key to confirm the operation, you can press the
【 SHIFT 】 button again to turn off its indicator, and the operation is cancelled.
During the operation, the 【 SHIFT 】 indicator will flash to show the operation
status: one time flash means data changed; two times flash means data
out-of-range and not changed; three times flash means data confirmed or sent.
5.5.2 Bank LSB Select
z Operation：【SHIFT】ÖA1【Bank LSB Select】Ö【Set value】Ö【ENTER】
15