User`s manual

12
product. The 3 pedals will flash for 5 times, then the reset operation is
completed.
z The reset operation will clear all the settings, you have made to the product.
4 Settings
4.1 Polarity
z If you find a pedal is working in the reverse way, please change its polarity
setting.
z Please depress the pedal you want to change, and power on the product, then
the pedal polarity is changed.
4.2 Range
z You can adjust the data range of PEDAL3 .
z To adjust the data range, please use the fine tuning knob（TRIM.）.
4.3 Assign Controller#
z By assigning a controller#, you can change the sent out MIDI messages of a
pedal, for the MIDI OUT and the USB port.
z Follow the below steps to assign a controller#:
I. After you power on the product, depress all the three pedals for 3 seconds.
Then the 3 LEDs flash slowly to show, that the product is ready for assigning
controller#.
II. Depress one of the three pedals, to select the pedal you want to assign.
Now only the corresponded LED flashes slowly, the other two LEDs go off.
III. Depress the three pedals in turn, to assign the controller#. Use PEDAL1 to
change the hundred digit, use PEDAL2 to change the tenth digit, use
PEDAL3 to change the most right digit. As you depress the pedal, the digit
will increase by one from 0-9, and the corresponded LED will flash once.
z Please refer to《Controller list》in a later chapter.
z If no pedal is depressed for 3 seconds, after you entered the controller#