Specifications

3GPP
3GPP TS 27.007 V6.3.0 (2003-
06)
5
1
Release 6
<m> (parameter shows the subscriber CLIR service status in the network):
0 CLIR not provisioned
1 CLIR provisioned in permanent mode
2 unknown (e.g. no network, etc.)
3 CLIR temporary mode presentation restricted
4 CLIR temporary mode presentation allowed
Implementation
Optional.
7.8 Connected line identification presentation +COLP
Table 41: +COLP parameter command syntax
Command
Possible response(s)
+COLP=[<n>]
+COLP?
+COLP: <n>,<m>
+COLP=?
+COLP: (list of supported <n>s)
Description
This command refers to the GSM/UMTS supplementary service COLP (Connected Line Identification Presentation)
that enables a calling subscriber to get the connected line identity (COL) of the called party after setting up a mobile
originated call. The command enables or disables the presentation of the COL at the TE. It has no effect on the
execution of the supplementary service COLR in the network.
When enabled (and called subscriber allows), +COLP:
<number>,<type>[,<subaddr>,<satype> [,<alpha>]] intermediate result code is returned from TA to
TE before any +CR or V.250 [14] responses. It is manufacturer specific if this response is used when normal voice call
is established.
Read command gives the status of <n>, and also triggers an interrogation of the provision status of the COLP service
according 3GPP TS 22.081 [3] (given in <m>).
Test command returns values supported as a compound value.
Defined values
<n> (parameter sets/shows the result code presentation status to the TE):
0
disable
1 enable
<m> (parameter shows the subscriber COLP service status in the network):
0 COLP not provisioned
1 COLP provisioned
2 unknown (e.g. no network, etc.)
<number>, <type>, <subaddr>, <satype>, <alpha>: refer +CLIP
Implementation
Optional.