Specifications

3GPP

3GPP TS 27.007 V6.3.0 (2003-

06)

Release 6

Description

Action command sets a new password for the facility lock function defined by command Facility Lock +CLCK. Refer

subclause 9.2 for possible <err> values.

Test command returns a list of pairs which present the available facilities and the maximum length of their password.

Defined values

<fac>:

"P2" SIM PIN2

refer Facility Lock +CLCK for other values

<oldpwd>, <newpwd>: string type; <oldpwd> shall be the same as password specified for the facility from the

MT user interface or with command Change Password +CPWD and <newpwd> is the new password; maximum

length of password can be determined with <pwdlength>

<pwdlength>: integer type maximum length of the password for the facility

Implementation

Optional.

7.6 Calling line identification presentation +CLIP

Table 39: +CLIP parameter command syntax

Command

Possible response(s)

+CLIP=[<n>]

+CLIP?

+CLIP: <n>,<m>

+CLIP=?

+CLIP: (list of supported <n>s)

Description

This command refers to the GSM/UMTS supplementary service CLIP (Calling Line Identification Presentation) that

enables a called subscriber to get the calling line identity (CLI) of the calling party when receiving a mobile terminated

call. Set command enables or disables the presentation of the CLI at the TE. It has no effect on the execution of the

supplementary service CLIP in the network.

When the presentation of the CLI at the TE is enabled (and calling subscriber allows), +CLIP:

<number>,<type>[,<subaddr>,<satype>[,[<alpha>][,<CLI validity>]]] response is returned

after every RING (or +CRING: <type>; refer subclause "Cellular result codes +CRC") result code sent from TA to

TE. It is manufacturer specific if this response is used when normal voice call is answered.

Read command gives the status of <n>, and also triggers an interrogation of the provision status of the CLIP service

according 3GPP TS 22.081 [3] (given in <m>).Test command returns values supported as a compound value.

Defined values

<n> (parameter sets/shows the result code presentation status to the TE):

disable

1 enable

<m> (parameter shows the subscriber CLIP service status in the network):

0 CLIP not provisioned

1 CLIP provisioned

2 unknown (e.g. no network, etc.)