Specifications

3GPP

3GPP TS 27.007 V6.3.0 (2003-

06)

Release 6

disables extended format

1 enables extended format

<type>:

ASYNC [,<priority>[,<subaddr>,<satype>]] asynchronous transparent

SYNC [,<priority>[,<subaddr>,<satype>]] synchronous transparent

REL ASYNC [,<priority>[,<subaddr>,<satype>]] asynchronous non-transparent

REL SYNC [,<priority>[,<subaddr>,<satype>]] synchronous non-transparent

FAX [,<priority>[,<subaddr>,<satype>]] facsimile (TS 62)

VOICE [,<priority>[,<subaddr>,<satype>]] normal voice (TS 11)

VOICE/XXX [,<priority>[,<subaddr>,<satype>]] voice followed by data (BS 81) (XXX is

ASYNC, SYNC, REL ASYNC or REL SYNC)

ALT VOICE/XXX [,<priority>[,<subaddr>,<satype>]] alternating voice/data, voice first (BS 61)

ALT XXX/VOICE [,<priority>[,<subaddr>,<satype>]] alternating voice/data, data first (BS 61)

ALT VOICE/FAX [,<priority>[,<subaddr>,<satype>]] alternating voice/fax, voice first (TS 61)

ALT FAX/VOICE [,<priority>[,<subaddr>,<satype>]] alternating voice/fax, fax first (TS 61)

GPRS <PDP_type>, <PDP_addr>[, [<L2P>][,<APN>]] GPRS network request for PDP context

activation

VGC <GCA>, <GId>, <ackflag> [,<priority>] voice group call (TS 91)

VBC <GCA>, <GId>, <ackflag> [,<priority>] voice broadcast call (TS 92)

The optional <priority> indicates the eMLPP priority level of the incoming call by paging, notification or setup

message. The priority level values are as defined in eMLPP specification 3GPP TS 22.067 [54].

<subaddr>: string type subaddress of format specified by <satype>

<satype>: type of subaddress octet in integer format (refer 3GPP TS 24.008 [8] subclause 10.5.4.8)

<PDP_type> ,<PDP_addr> and <APN> are as defined in the Define PDP Context (+CGDCONT) command. The

optional <L2P> proposes a layer 2 protocol to use between the MT and the TE. It is defined in the Enter GPRS Data

Mode (+CGDATA) command. If the MT is unable to announce to the TE the network's request (for example it is in

V.250 online data state) the MT shall reject the request. No corresponding unsolicited result code shall be issued when

the MT returns to a command state.

<GCA> is a part of the group call reference as specified in 3GPP TS 23.003 [7] and indicates group call area.

<GId> is a part of the group call reference as specified in 3GPP TS 23.003 [7] and indicates group call

identification.The <ackflag>=1 proposes that a predefined confirmation procedure is to be used after the call is ended.

For <ackflag>=0 no confirmation procedure is required.

Implementation

Mandatory when data or fax circuit mode calls implemented or for a MT supporting AT commands only and eMLPP or

VGCS or VBS is implemented.