Specifications

3GPP
3GPP TS 27.007 V6.3.0 (2003-
06)
11
9
Release 6
<Guaranteed bitrate DL>: a numeric parameter that indicates the guaranteed number of kbits/s delivered
by UMTS (down-link traffic) at a SAP (provided that there is data to deliver). As an example a bitrate of
32kbit/s would be specified as '32' (e.g. AT+CGEQREQ=…,32, …). If the parameter is set to '0' the subscribed
value will be requested. This parameter should be provided if the Traffic class is specified as conversational or
streaming.
<Delivery order>: a numeric parameter that indicates whether the UMTS bearer shall provide in-sequence
SDU delivery or not.
0 - no
1 - yes
2 - subscribed value.
Other values are reserved.
<Maximum SDU size>: a numeric parameter (1,2,3,…) that indicates the maximum allowed SDU size in octets.
If the parameter is set to '0' the subscribed value will be requested.
<SDU error ratio>: a string parameter that indicates the target value for the fraction of SDUs lost or detected
as erroneous. SDU error ratio is defined only for conforming traffic. The value is specified as 'mEe'. As an
example a target SDU error ratio of 5•10
-3
would be specified as '5E3' (e.g. AT+CGEQREQ=…,”5E3”,…). '0E0'
means subscribed value.
<Residual bit error ratio>: a string parameter that indicates the target value for the undetected bit error
ratio in the delivered SDUs. If no error detection is requested, Residual bit error ratio indicates the bit error ratio
in the delivered SDUs. The value is specified as 'mEe'. As an example a target residual bit error ratio of 5•10
-3
would be specified as '5E3' (e.g. AT+CGEQREQ=…,”5E3”,…). '0E0' means subscribed value.
<Delivery of erroneous SDUs>: a numeric parameter that indicates whether SDUs detected as erroneous
shall be delivered or not.
0 - no
1 - yes
2 - no detect
3 - subscribed value
Other values are reserved.
<Transfer delay>: a numeric parameter (0,1,2,…) that indicates the targeted time between request to transfer
an SDU at one SAP to its delivery at the other SAP, in milliseconds. If the parameter is set to '0' the subscribed
value will be requested.
<Traffic handling priority>: a numeric parameter (1,2,3,…) that specifies the relative importance for
handling of all SDUs belonging to the UMTS bearer compared to the SDUs of other bearers. If the parameter is
set to '0' the subscribed value will be requested.
<PDP_type>: (see +CGDCONT and +CGDSCONT commands).
If a value is omitted for a particular class then the value is considered to be unspecified.
Implementation
Optional. If the command is not implemented then all the values are considered to be unspecified.
10.1.7 3G Quality of Service Profile (Minimum acceptable) +CGEQMIN
Table 110: +CGEQMIN parameter command syntax
Command
Possible Response(s)
+CGEQMIN=[<cid> [,<Traffic class>
[,<Maximum bitrate UL> [,<Maximum
bitrate DL> [,<Guaranteed bitrate UL>
[,<Guaranteed bitrate DL> [,<Delivery
order> [,<Maximum SDU size> [,<SDU
error ratio> [,<Residual bit error
ratio> [,<Delivery of erroneous SDUs>
[,<Transfer delay> [,<Traffic handling
priority>]]]]]]]]]]]]]
OK
ERROR