Specifications

3GPP
3GPP TS 27.007 V6.3.0 (2003-
06)
11
6
Release 6
10.1.5 Quality of Service Profile (Minimum acceptable) +CGQMIN
Table 108: +CGQMIN parameter command syntax
Command
Possible Response(s)
+CGQMIN=[<cid> [,<precedence > [,<delay>
[,<reliability.> [,<peak> [,<mean>]]]]]]
OK
ERROR
+CGQMIN?
+CGQMIN: <cid>, <precedence >, <delay>,
<reliability>, <peak>, <mean>
[<CR><LF>+CGQMIN: <cid>, <precedence >,
<delay>, <reliability.>, <peak>, <mean>
[…]]
+CGQMIN=?
+CGQMIN: <PDP_type>, (list of supported
<precedence>s), (list of supported
<delay>s), (list of supported
<reliability>s) , (list of supported
<peak>s), (list of supported <mean>s)
[<CR><LF>+CGQMIN: <PDP_type>, (list of
supported <precedence>s), (list of
supported <delay>s), (list of supported
<reliability>s) , (list of supported
<peak>s), (list of supported <mean>s)
[…]]
Description
This command allows the TE to specify a minimum acceptable profile which is checked by the MT against the
negotiated profile returned in the Activate PDP Context Accept message.
The set command specifies a profile for the context identified by the (local) context identification parameter, <cid>.
Since this is the same parameter that is used in the +CGDCONT and +CGDSCONT commands, the +CGQMIN
command is effectively an extension to these commands. The QoS profile consists of a number of parameters, each of
which may be set to a separate value.
A special form of the set command, +CGQMIN= <cid> causes the minimum acceptable profile for context number
<cid> to become undefined. In this case no check is made against the negotiated profile.
The read command returns the current settings for each defined context.
The test command returns values supported as a compound value. If the MT supports several PDP types, the parameter
value ranges for each PDP type are returned on a separate line.
Defined values
<cid>: a numeric parameter which specifies a particular PDP context definition (see the +CGDCONT and
+CGDSCONT commands).
The following parameters are defined in -3GPP TS 23.107 [46]:
<precedence>: a numeric parameter which specifies the precedence class
<delay>: a numeric parameter which specifies the delay class
<reliability>: a numeric parameter which specifies the reliability class
<peak>: a numeric parameter which specifies the peak throughput class
<mean>: a numeric parameter which specifies the mean throughput class
If a value is omitted for a particular class then this class is not checked.