Specifications

3GPP
3GPP TS 27.007 V6.3.0 (2003-
06)
11
4
Release 6
Defined values
<cid>: a numeric parameter which specifies a particular PDP context definition (see the +CGDCONT and
+CGDSCONT commands).
The following parameters are defined in 3GPP TS 23.060[47] -
<packet filter identifier>: Numeric parameter, value range from 1 to 8.
<source address and subnet mask>: Consists of dot-separated numeric (0-255) parameters on the form
'a1.a2.a3.a4.m1.m2.m3.m4', for IPv4 and
'a1.a2.a3.a4.a5.a6.a7.a8.a9.a10.a11.a12.a13.a14.a15.a16.
m1.m2.m3.m4.m5.m6.m7.m8.m9.m10.m11.m12.m13.m14.m15.m16', for IPv6.
<protocol number (ipv4) / next header (ipv6)>: Numeric parameter, value range from 0 to 255.
<destination port range>: Consists of dot-separated numeric (0-65535) parameters on the form 'f.t'.
<source port range>:Consists of dot-separated numeric (0-65535) parameters on the form 'f.t'.
<ipsec security parameter index (spi)>: Hexadecimal parameter,
value range from 00000000 to FFFFFFFF.
<type of service (tos) (ipv4) and mask / traffic class (ipv6) and mask>:
Dot-separated numeric (0-255) parameters on the form 't.m'.
<flow label (ipv6)>: Hexadecimal parameter, value range from 00000 to FFFFF. Valid for IPv6 only.
<evaluation precedence index>: Numeric parameter, value range from 0 to 255.
Some of the above listed attributes may coexist in a Packet Filter while others mutually exclude each other, the possible
combinations are shown in 3GPP TS 23.060[47].
Implementation
Optional.
10.1.4 Quality of Service Profile (Requested) +CGQREQ
Table 107: +CGQREQ parameter command syntax
Command
Possible Response(s)
+CGQREQ=[<cid> [,<precedence > [,<delay>
[,<reliability.> [,<peak> [,<mean>]]]]]]
OK
ERROR
+CGQREQ?
+CGQREQ: <cid>, <precedence >, <delay>,
<reliability>, <peak>, <mean>
[<CR><LF>+CGQREQ: <cid>, <precedence >,
<delay>, <reliability.>, <peak>, <mean>
[…]]
+CGQREQ=?
+CGQREQ: <PDP_type>, (list of supported
<precedence>s), (list of supported
<delay>s), (list of supported
<reliability>s) , (list of supported
<peak>s), (list of supported <mean>s)
[<CR><LF>+CGQREQ: <PDP_type>, (list of
supported <precedence>s), (list of
supported <delay>s), (list of supported
<reliability>s) , (list of supported
<peak>s), (list of supported <mean>s)
[…]]