Specifications

3GPP
3GPP TS 27.007 V6.3.0 (2003-
06)
11
0
Release 6
3 - RFC2507
4 - RFC3095 (applicable for PDCP only)
Other values are reserved.
<pd1>, … <pdN>: zero to N string parameters whose meanings are specific to the <PDP_type>
Implementation
Mandatory unless only a single subscribed context is supported.
10.1.2 Define Secondary PDP Context +CGDSCONT
Table 105: +CGDSCONT parameter command syntax
Command
Possible response(s)
+CGDSCONT=[<cid> ,<p_cid> [,<d_comp>
[,<h_comp>]]]
OK
ERROR
+CGDSCONT?
+CGDSCONT: <cid>, <p_cid>, <d_comp>,
<h_comp>
[<CR><LF>+CGDSCONT: <cid>, <p_cid>,
<d_comp>, <h_comp>
[...]]
+CGDSCONT=?
+CGDSCONT: (range of supported <cid>s),
(list of <cid>s for active primary
contexts), <PDP_type>,,,(list of
supported <d_comp>s),
(list of supported <h_comp>s)
[<CR><LF>+CGDCONT: (range of supported
<cid>s), (list of <cid>s for active
primary contexts) ,<PDP_type>,,,(list of
supported <d_comp>s),
(list of supported <h_comp>s)
[...]]
Description
The set command specifies PDP context parameter values for a Secondary PDP context identified by the (local) context
identification parameter, <cid>. The number of PDP contexts that may be in a defined state at the same time is given
by the range returned by the test command.
A special form of the set command, +CGDSCONT= <cid> causes the values for context number <cid> to become
undefined.
The read command returns the current settings for each defined context.
The test command returns values supported as a compound value. If the MT supports several PDP types,
<PDP_type>, the parameter value ranges for each <PDP_type> are returned on a separate line.
Defined values
<cid>: (PDP Context Identifier) a numeric parameter which specifies a particular PDP context definition. The
parameter is local to the TE-MT interface and is used in other PDP context-related commands. The range of
permitted values (minimum value = 1) is returned by the test form of the command.
<p_cid>: (Primary PDP Context Identifier) a numeric parameter which specifies a particular PDP context
definition which has been specified by use of the +CGDCONT command. The parameter is local to the TE-MT
interface. The list of permitted values is returned by the test form of the command.
<PDP_type>: (Packet Data Protocol type) a string parameter which specifies the type of packet data protocol
X.25 ITU-T/CCITT X.25 layer 3 (Obsolete)
IP Internet Protocol (IETF STD 5)
IPV6 Internet Protocol, version 6 (IETF RFC 2460)