Operation Manual

NOTE: If you don’t receive an SMS on your cell phone or if the message says ERROR / NO CODE, it means the

system has not been able to process the data you have sent. Do not try sending another SMS use the MANUAL

SEARCH instead.

SETTING CODES USING A MANUAL SEARCH

(only to be performed if the speciﬁ c code could not be found)

CHECK

Check that the other buttons correspond to the functions of the original remote control; if not, it is likely that the code

found is incorrect, but is used for a very similar device. In that case, repeat the procedure from point 2.

If the manual search for the code is successful, obtain the code in use by following the DISPLAY CODE IN USE

procedure and make a note of it inside the battery cover.

1. Switch on the device to be programmed:

- if it is a TV, SAT or TER select a programme

- if it is a DVD insert a DVD.

- if it is a VCR insert a cassette.

2. Press and hold down for 6 seconds the device selection

button corresponding to the device you wish to enter the

code for.

3. Release the button. The indicator light will ﬂ ash. Point

the remote control at the device and press the ON/OFF

key (or PLAY if it is a VCR/DVD). If the device does NOT

switch off (or if the VCR/DVD does not start playing)

press the same button again slowly (it may be necessary

to press the button several times).

4. When the device responds correctly, press OK. Three

long ﬂ ashes indicate that the operation has been carried

out correctly.

Point the CME remote control at the device, which should already be ON and press the ON/OFF button on the remote (or

the PLAY button if the device is a VCR/DVD).

If the device does NOT switch off (or if the VCR/DVD does not start playing), try setting the consecutive code in the SMS

list in the remote control.

When the device reacts check whether the other buttons are operating correctly too.

If they do, the remote control is ready to use.

If they don’t, you are probably using an incorrect code destined for a very similar device; at this point ignore the

SMS list and consult the SETTING CODES USING A MANUAL SEARCH section to ﬁ nd a more suitable code.

6 SEC.

or or oror