Operation Manual

ManualsBrandsCme ManualsRemote ControlCONTROL 5 Digital

Digital

Keep this booklet for future reference.

Thank you for choosing a CME remote control.

The Control 5 digital remote control is ideal for replacing up to 5 remote controls for TV - SAT (satellite decoder) - TER

(Digital Terrestrial decoder) - DVD (Dvd player and Blu Ray) – PVR (Personal Video Recorder, Media Center and VCR). The

remote control has a permanent memory, so it does not lose its settings even if there are no batteries in it.

IMPORTANT: The remote control must not be exposed to excessive heat sources.

USE OF THE BUTTONS AND FUNCTIONS

The functions of the buttons described below are available only if they are on your original device.

ON/OFF switches the device OFF and

in some cases ON

Numeric keypad

Conﬁ rm selection

For selecting an external

input source

For selecting the next programme

P+ or the previous programme P–

For moving around within the MENU

TELETEXT buttons

Buttons for selecting the device to be

controlled.

Fastext functions or for selecting sub-

menus using colours

DVD/PVR RECORD PAUSE

STOP PLAY buttons

DVD and PVR forward/back functions

Speciﬁ c buttons for decoder

Selects digital TV and radio

MUTE turns sound OFF and ON

Volume control +/–

Selects analogue/digital

Summary of content (5 pages)

PAGE 1
EN I Digital Thank you for choosing a CME remote control. Keep this booklet for future reference. The Control 5 digital remote control is ideal for replacing up to 5 remote controls for TV - SAT (satellite decoder) - TER (Digital Terrestrial decoder) - DVD (Dvd player and Blu Ray) – PVR (Personal Video Recorder, Media Center and VCR). The remote control has a permanent memory, so it does not lose its settings even if there are no batteries in it.
PAGE 2
Before using the remote control, insert the batteries and programme it. INSERTING THE BATTERIES The remote control requires 2 new 1.5V alkaline AAA/LR03 batteries. Insert them as illustrated. Try pressing a number button and check that the red light remains lit continuously until you release the button. If the light flashes, the batteries inserted are not charged and are about to go flat, therefore you must substitute them.
PAGE 3
Point the CME remote control at the device, which should already be ON and press the ON/OFF button on the remote (or the PLAY button if the device is a VCR/DVD). If the device does NOT switch off (or if the VCR/DVD does not start playing), try setting the consecutive code in the SMS list in the remote control. When the device reacts check whether the other buttons are operating correctly too. If they do, the remote control is ready to use.
PAGE 4
NOTE: During the search the indicator stops flashing and the remote control exits the programming mode in the following cases: • if for 12 seconds the button indicated is not pressed or if another button is pressed • if the list of codes to find is terminated. If this happens, visit the www.cme.it website ENTERING THE CODE DIRECTLY (only to be performed if you know the specific code to be set) 1.
PAGE 5
TROUBLESHOOTING PROBLEM The device does not respond and the indicator light does not come on when a button is pressed. SOLUTION Check that the batteries are charged and inserted correctly and if necessary replace them with 2 new 1,5 V AAA/LR03 alkaline type batteries. The device does not respond but the indicator light comes on. Make sure that the remote control is pointing at the device and that there are no obstacles in the way.