User`s manual

19
6.7 Pedal
z For the two pedal jacks, each one can be used for continuouls pedal (e.g volume
pedal) or switch pedal (e.g sustain pedal).
z By default, PEDAL A is for sustain pedal and send CC#64 message, the data value
is either 0 or 127(switch data); PEDAL B is for volume pedal and send CC#11
message, the data range is 0-127(continuous data).
z To change pedal type or polarity, please use the system settings function (9.3-9.6).
You can customize the MIDI data to be sent using the 【ASSIGN】function (8.1).
6.8 Breath Controller
z Use the breath control jack for a breath controller such as YAMAHA BC3 and send
out the MIDI data.
You can customize the MIDI data to be sent using the 【ASSIGN】function (8.1).
By turning the gain and fine tune knobs in the breath controller, you get a good
breath feeling and data range.
6.9 Aftertouch
z After pressing a key, you can continue applying force to send channel after touch
data.
z You can adjust the data sending rate or turn off those MIDI data (9.2).
z Please refer to the appendix <After touch curve list>.
You can customize the MIDI data to be sent using the 【ASSIGN】function (8.1).
6.10 Bank Selection And Program Change (Patch)
6.10.1 Bank MSB Select
z Operation：【SHIFT】ÖC1【Bank MSB Select】Ö【Set value】Ö【ENTER】
z MIDI message sent：CC#0 + CC#32 + Program
z Default value：0
z Value range：0-127
6.10.2 Bank LSB Select
z Operation：【SHIFT】ÖC#1【Bank LSB Select】Ö【Set value】Ö【ENTER】
z MIDI message sent：CC#0 + CC#32 + Program
z Default value：0
z Value range：0-127