User`s manual

with on-board termination (see manufac- 1
turer's documentation) or
by using an ex-
ternal terminator.
Be sure devices in the middle of the SCSI
bus are not terminated (see Figure 4).
The CBI-IOIO is factory configured with 2
on-board termination.
Connect a terminal to the
CBI-
1010's RS-232 port (DB-25 con-
nector or
DEC compatible RJ-
11/Modified Module 423 Jack
connector of the back panel
adapter kit).
Set the terminal baud rate to
9600 (8-bit data, I-stop bit, no
parity).
Halt the system' s
CPU, reset
3
Set the devices SCSI ID numbers to the -
specifications set forth in "SCSI ID for 3
Target
Devices" (see manufacturer's docu-
mentation for setting devices
SCSI ID).
the system,
and hit carriage re- Figure 2: Back Panel (Differential)
tum on the terminal.
On-Board Utility
The On-Board Utility can be used to change
the system configuration for
use with the CBI-
1010 and other special features. To access the
RS-232 utility, follow the instructions below.
SCSI Bus Cable
SCSI
10=7 T
SCSI
Device
SCSI
Device
4
Once the main utility menu
shows
up, you can key in the
number to select the desired
option.
Press [CTRl] + C at any
time to return to the main
menu.
Refer the the next subsections
for configurations.
When completed,
unplug the terminal,
SCSI
10=2 T
reset the system, and
boot.
00 NOT use
the
On-Board Utility
while the system is
running. Refer to
CBI-1010 User's
Manual, Chapter 4
SCSI
Device
for further details.
CBI-1010 In Host
Computer
T
Indicates SCSI bus termination.
Figure 4: SCSI cabling .
Figure 3: Back Panel (Single Ended)
CMD TECHNOLOGY, INC.
1 Vanderbilt Irvine, CA 92718
[phone]
(714)
454-0800 .