User`s manual

_.- -- ---------
CBI-1010 Quick Reference Guide
Installing the CBI-1 01 0
Pin 1 of the cable must match CON1
pin 1 of the backplane.
1
Turn off the system. If you need to change
Solder side of CSI-101O
Connect JE CON2 of the ribbon cable to IE
Component side of CBI-101O
,
6
the configuration for the
CBI-1010 see sec-
,
,
,
CON2 of the back panel.
tion, "Hardware Configuration," Chapter
,
3 of the CBI-1010 User's Manual.
Blue Node ID PI~
JA Connector
7
Connect the 10-pin RS-232 cable to
the
Make sure you are wearing
,
back panel at J1 (see Figures 2 and 3).
,
JB Connector
:
anti-static wrist straps.
CONl pin
.
· .
· . · .
Installing SCSI Devices
Choose a correct slot for installing the
· .
2
· .
CBI-1010 by reading the section "System
· .
JC Connector
Be sure you have successfully installed the
· .
Node ID."
· .
CBI-1010 into your system. Then follow these
· .
I • •
~ .. instructions to install SCSI devices:
· .
3
Install the CBI-1010 in the correct slot with
· .
CON2 pin 1
• •
the ZIF connectors set into the system's
1
Connect SCSI cables as listed below for
backplane;
push the ZIP handle down to
CONl pin
•
the specified mode (see examples in Fig-· .
clamp the CBI-1010 into place.
· .
ures 2 and 3):
JD Connector
48
Differential: Install the back panel into
For single-ended mode: Connect a SCSI cable
the back of the system
with the ribbon ca-
from the back panel
at the label "Single-
ble inside the system. If necessary, move
CON2 pin 1
Ended" to the SCSI devices (see "Cable
external connector to
"SCSI Differential"
Specifications"). The
sum total of the in-
slot
on back panel. (See Figure 2.)
CONl pin
·
ternal and external cable lengths must not
·
·
•
exceed 3 meters (9.9 ft.) at 10 MBytes/sec.
·
·
·
·
4b
Single Ended: Install the back panel into
~
·
·
·
·
the back of the system with the ribbon ca-
·
·
For differential mode: Connect a SCSI cable
·
·
JE Connector
·
·
ble inside the system. If necessary, move
~
·
·
from the back panel at the label "Single-
•
·
external connector to J'lSCSI Single Ended"
·
·
Ended" to the SCSI devices (see "Cable
·
·
slot on back panel. (See Figure 3.)
·
•
CON2 pin 1
Specifications"). The sum total of the in-
·
·
ternal and external cable lengths must not
5
Locate the 60-pin ribbon cable and con-
exceed
SO-feet.
nect cable labeled JE CON1 to JE CON1 of
the back panel (see Figure
1).
Figure 1: VAXBI backplane COMectors
2
Terminate the
physical ends of the SCSI
bus by terminating the last SCSI device