User`s manual

CBI-1010
SCSI ID-The bit-significant representation of the SCSI address referring to
one
of the signal lines DB (7-0).
SCSI
device-A host computer adapter or a peripheral controller or an
intelligent peripheral that can be attached to the SCSI bus.
Target-A SCSI device that performs an operation requested by an initiator.
SCSI Commands
SCSI commands used by CBI-1010 for MSCP emulation are listed in Table
5-1. The Format
Unit command is used by the On-Board Utility only. These
commands are used if the drives support them.
Table 5-1
Code
OOh
01h
03h
04h
07h
08h
OAh
OBh
12h
15h
16h
17h
1Ah
1Bh
1Eh
25h
28h
2Ah
2Bh
3Eh
3Fh
5-2 SCSI Library
SCSI Commands (MSCP)
Command Name
Test Unit Ready
Rezero Unit
Request Sense
Format Unit
(l)
Reassign Block
Read
Write
Seek
Inquiry
Mode Select
Reserve Unit
Release Unit
Mode Sense
Start/Stop Unit
Prevent/ Allow Medium Removal
Read Capacity
Extended Read
Extended Write
Extended Seek
Read Long
(2)
Write Long(2)