User`s manual

CBI-tOtO
4 Name the tape drives and list drive unit by entering the following line:
disk raO at uq# drive~
disk ral at uq# drive~
Where
# = the same number used to represent the controller in step 3.
~ = the DU number in the On-Board Utility displays this configuration.
CBI-1 01 O/TM
Edit the configuration file by performing the following instructions for the
CBI-1010/TM. Note the CBI-I010/TM must be configured with a higher klesiu
number, higher uq number, and higher tms numbers than any other klesiu
controller; and a higher uda number, higher uq number, and higher ra number
than any other uba controller in the configuration file.
1 Make sure the following two lines are in the configuration file:
adapter xmiO at nexus? (this line only for VAX 6000's and 5810's)
adapter vaxbi& at nexus?
Where
? = the system will fill in this variable (simply enter this? ).
& = the XMI node ID of the XMI to BI adapter for 6000's and 5810's (on
8200's use 0, zero, for the variable).
2 Connect the controller to the node
on the BI bus by entering the
following line:
controller ubat1 at vaxbi& node XX
Where
t1 = the variable number that represents the CBI-1010 /TM.
& = the same number used in step 1.
XX = the node ID of the VAXBI slot that contains the CBI-1010/TM.
Setup 4-21